Skip to content

Filters

Hunter Flow-Clik Sensor

When ruptures or leaks occur, Flow-Clik ensures water flow is stopped immediately
Hunter created the Flow-Clik flow sensor to guard against these damages in the event of a rupture. The Flow-Clik can be programmed at a specified level of flow. It will shut down irrigation if it detects a flow rate higher than the programmed limit. Therefore, the amount of water loss and system damage is substantially reduced in the event of high external leakage.
  • Hunter FCT-100 Flow Clik Sensor Tee 1" SCH40
    Hunter FCT-100 Flow Clik Sensor Tee 1" SCH40 Save 28%
    $105.08
    $76.18
    Hunter

    Hunter - FCT100 - Flow-Clik Sensor Tee

    In Stock (6)

    1" Schedule 40 Sensor Receptacle Tee Inlet/Outlet: Slip Hunter FCT100 A ruptured pipe or broken sprinkler left undetected can result in substanti...

    View full details
    $105.08
    $76.18
    Save 28%
    In Stock (6)
Specifications
  • Flow-Clik Interface Panel 36" leads provided for easy wiring to controller (2 wires to controller 24 VAC terminals and 2 wires to sensor and terminals)
  • Current draw: 24 VAC, 0.025 A
  • Switching current: 2 A maximum
  • Max. distance between interface panel and sensor: 1000 ft. (18AWG minimum wire size); 2 wires required for Flow-Clik sensor; 4 wires required for Flow-Clik IMMS™ sensor
  • Programmable start up delay: 0 to 300 seconds
  • Programmable interrupt period: 2 to 60 minutes
  • System status indicator light
  • One button system calibration to set highest flow zone