Skip to content

Filters

Hunter Flow-Clik Sensor

When ruptures or leaks occur, Flow-Clik ensures water flow is stopped immediately
Hunter created the Flow-Clik flow sensor to guard against these damages in the event of a rupture. The Flow-Clik can be programmed at a specified level of flow. It will shut down irrigation if it detects a flow rate higher than the programmed limit. Therefore, the amount of water loss and system damage is substantially reduced in the event of high external leakage.
  • Close-up of Hunter FCT-200 2" Schedule 40 Flow-Clik sensor tee highlighting the sensor receptacle and solvent-weld slip connection ends.
    Angled view of Hunter FCT-200 2" Schedule 40 PVC flow sensor receptacle tee showing slip x slip connections and sensor pocket for Flow-Clik. Save 25%
    $164.74
    $123.55
    Hunter

    Hunter FCT-200 2" Schedule 40 Flow-Clik Sensor Tee

    In Stock (2)

    The Hunter FCT-200 is a Schedule 40, 2" (50 mm) sensor receptacle tee engineered to accept Hunter Flow‑Clik / Flow‑Sync sensors and integrate flow ...

    View full details
    $164.74
    $123.55
    Save 25%
    In Stock (2)
  • Close-up of Hunter FCT-150 Flow-Clik sensor receptacle tee, 1-1/2" SCH40 PVC fitting showing tee profile and sensor receptacle opening.
    Front view of Hunter FCT-150 Schedule 40 sensor tee, 1-1/2" slip x slip PVC fitting showing inlet and outlet ports for sensor placement.
    Save 25%
    $131.56
    $98.67
    Hunter

    Hunter FCT-150 1 1/2" Schedule 40 Flow Sensor Tee

    In Stock (7)

    The Hunter FCT-150 is a Schedule 40 sensor receptacle tee engineered for use with Hunter Flow-Clik sensors. It provides a secure, in-line mounting ...

    View full details
    $131.56
    $98.67
    Save 25%
    In Stock (7)
Specifications
  • Flow-Clik Interface Panel 36" leads provided for easy wiring to controller (2 wires to controller 24 VAC terminals and 2 wires to sensor and terminals)
  • Current draw: 24 VAC, 0.025 A
  • Switching current: 2 A maximum
  • Max. distance between interface panel and sensor: 1000 ft. (18AWG minimum wire size); 2 wires required for Flow-Clik sensor; 4 wires required for Flow-Clik IMMS™ sensor
  • Programmable start up delay: 0 to 300 seconds
  • Programmable interrupt period: 2 to 60 minutes
  • System status indicator light
  • One button system calibration to set highest flow zone

Add a FREE Pair of Gloves to Your Order

Spend $35+ Add a FREE Pair of Gloves to Your Order Select Your Size